Free fitting for water coolers
We offer a fully professional free of charge installation service on our rented water coolers, regardless of the distance between the water supply and location of cooler. Unlike other companies who use the cheap option of a saddle valve system when connecting to your mains water we isolate your water and fit 15mm compression T Piece. The problems with a saddle valve are that if there is a leak in the system there is no way you can shut off the water supply between the valve and the cooler which could involve a lot of water leaking. Also the saddle valve only pierces a small hole in your mains water pipe, which can “fur” up and cause the water pressure to be very low through the coolers.
After connecting to the mains water we then fit a water block that consists of two parts, a non-return valve and a leak detector valve. The non-return valve stops water from flowing back into your mains water pipes which could cause the pipes to burst. The leak detector valve senses when 2 gallons of water has continually passed through to the cooler and automatically shuts off the water supply, as it knows there may be a possibility of a leak. This gives you full peace of mind and stops there from being any damage to your premises. We then use flexible micro bore piping to take the water to your cooler, which is neat and tidy, and blends into any décor. Behind each cooler we fit an extra isolation valve so that if there are any problems with a particular cooler, the water supply to that cooler can be shut off without it affecting the other coolers on your premises.
